Mount bracket for power steering pump oil cooler line - AR46.30-P-0510GH

MODEL 163.136 /154#A up to 043552 

when installing a new radiator with integrated power steering pump oil cooler 

Fig 1: Identifying Mount Bracket For Power Steering Pump Oil Cooler Line

	Install
1	Mark position of hole on outside of stabilizer bracket (3) with distance c =50 mm vertical to the upper edge and d =15 mm to the side.	Mark the distance (d) parallel to the slanted side.
2	Secure the bracket (1) on the inside of the front of the stabilizer bracket (3) with vise grip pliers.	Fit the bracket cleanly to the surface of the frame.
3	Drill a hole with dia. 6.5 mm through both the front of the stabilizer bracket (3) and bracket (1) at the same time	Place vent hose of front-axle differential to the side. Do not use existing hole in bracket (for E-coat process).
4	Coat holes with paint
5	Attach bracket (1) to inside of stabilizer bracket	Use self-locking nut.
6	Secure oil cooler line (4) to bracket (1) with rubber (5)	Only one rubber required. Remove second rubber from oil cooler line.