Retrofit wiring harness - AZ82.70-P-0001-04C

Model 163 as of 1.12.99 up to 31.8.00 for Nokia 6090 fixed installation CTEL 

1. Prepare telephone wiring harness (2) as shown in figure.
2. Tie back audio line-out cable with 4-pin connector (25) (is not required).
3. Expose two red (rt) and two black (sw) cables.
   Fig 1: Identifying Telephone Wiring Harness

   
4. Unlock catch (arrows) of connector (21) one detent.
5. Fit cable terminals (22) to the red (rt) leads and insert into chambers 3 and 9 of the connector (21).
6. Fit cable terminals (22) to the black (sw) leads and insert into chambers 4 and 6.
7. Insulate orange cable and tie back (is not required).
8. Fit cable terminal (22) to blue (bl) lead and insert into chamber 5.
9. Fit cable terminal (22) to yellow (ge) lead and insert into chamber 2.
10. Fit cable terminal (22) to gray (gr) lead and insert into chamber 7.
11. Lock connector (21).
    Fig 2: Identifying Lock Connector And Cable Terminals

    
12. Insert wiring harness (2) into instrument panel working from the glove compartment.

    The tied-back part must be placed below the strut (arrows) at the glove compartment.

    Fig 3: Identifying Telephone Wiring Harness

    
13. Connect telephone wiring harness (2) to adapter wiring harness (9).
14. Check fuse (23) (a 10A fuse should be present).
    Fig 4: Identifying Fuse And Telephone Wiring Harness

    
15. Connect adapter wiring harness (9) to radio wiring harness and insert into radio slot.
16. Place microphone cable of telephone wiring harness (2) into radio slot.
    Fig 5: Identifying Adapter Wiring Harness And Telephone Wiring Harness

    
17. Route connection cable of telephone wiring harness (2) to telephone handset in middle tunnel as shown in figure.
    Fig 6: Identifying Telephone Wiring Harness