Retrofit telephone console - AZ82.70-P-0001-01G

MODEL 163 as of 1.10.01 

1. Lay assembly plate (10) on telephone console (12) and align as shown in figure. Mark hole pattern and drill with 2.5 dia. bit.
2. Screw assembly plate (10) onto telephone console (12) with screws (11).
   Fig 1: Identifying Telephone Console And Assembly Plate

   
3. Insert mount (1) into assembly plate (10) and install spiral cable into groove (arrow) of telephone console (12) together with grommet.
   Fig 2: Identifying Mount, Assembly Plate And Telephone Console

   
4. Screw mount for console (14) to instrument panel with upper right mounting screw (arrow) of air conditioning control module.

   Holder for console (14) must be installed behind A/C control panel.

   Fig 3: Identifying Console And Screw

   
5. Route tieouts (A and B) for cellular telephone wiring harness (2) and antenna lead (17) to console (12) and connect.
6. Form excess lengths of the connection cables into a loop and secure with Velcro (18).
7. Route cables for connection plug (5) behind the center console to the right seat.
   Fig 4: Identifying Cellular Telephone Wiring Harness And Antenna Lead

   
8. Insert console (12) into mount holes on air conditioning control module using locating pin and align at instrument panel.
9. Mark hole for screw (13) and drill with 2.5 mm dia. bit.

   When drilling in instrument panel do not damage parts behind. 

10. Screw console (12) to instrument panel with screw (13).
    Fig 5: Identifying Console And Screw

    
11. Expose tied-back cables with coupling (5) behind the front passenger seat.
    Fig 6: Identifying Coupling

    
12. Connect antenna lines (arrow) and insulated with Velcro.
    Fig 7: Identifying Antenna Lines

    
13. Connect blue coupling to connection plug (5).
14. Tie back cables under the seat and secure with Velcro.
    Fig 8: Identifying Connection Plug