Brake shudder in cold state - AF42.10-P-3103A

MODEL 210 

Modification notes

18.3.97

Remedy changed

Damage code	Cause	Remedy:
42 101 H4	Thickness error in brake disk On model 210, the noise characteristics when the brakes shudder is slightly different than on the other models. During a test drive it is not always possible to clearly locate whether the shuddering comes from the front or rear axle	1 Check vehicle on dynamometer If complaint is reproducible ↓ 2 Measure lateral runout on rear axle brake disk (1 cm from edge of brake disk) If the lateral runout is > 0.08 mm ↓
		3 Replace wheel hub, wheel bearing and brake disk If lateral runout is < 0.08 mm ↓	AR35.20-P-0130B
		4 Replace brake disk only Brake lining can be reused	AR42.10-P-0220A