Tightening bolts or nuts to specified angles - AR35.10-P-0010-08IA
| Number | Designation | Model 215 | Model 220 | Model 230 | ||
|---|---|---|---|---|---|---|
| BA35.20-P-1001-01A | Self-locking nut, track control arm to rear subframe | Stage 1 | Nm | 50 | 50 | 50 |
| Stage 2 | ∠° | 90 | 90 | 90 | ||
- Tighten nut to tightening torque
, stage 1.
- Mark socket relative to spring control arm, marking (a).
- Place mark (b) on spring control arm offset by 90°.
- Tighten nut with rotation angle, 2nd stage
Markings (a) and (b) must then match.
Shown on right spring control arm, model 215