Tightening bolts or nuts to specified angles - AR35.10-P-0010-08I
| Number | Designation | Model 215 | Model 220 | |||
|---|---|---|---|---|---|---|
| BA35.10-P-1001-01A | Self-locking bolt, front rear axle carrier rubber mount to frame floor | Nm | - | - | ||
| with bolt | 1st stage | Nm | 60 | 60 | ||
| flange ø 24 mm | 2nd stage | ∠° | 90 | 90 | ||
| with bolt | 1st stage | Nm | 60 | 60 | ||
| flange ø 26mm | 2nd stage | ∠° | 90 | 90 | ||
| BA35.10-P-1002-01A | Self-locking bolt, rear axle carrier rear rubber mount to frame floor | Nm | - | - | ||
| with bolt | 1st stage | Nm | 60 | 60 | ||
| flange ø 24 mm | 2nd stage | ∠° | 90 | 90 | ||
| with bolt | 1st stage | Nm | 60 | 60 | ||
| flange ø 26mm | 2nd stage | ∠° | 90 | 90 | ||
- Tighten bolt to tightening torque: 1st stage.
- Mark plug-in socket relative to stop disk on front rubber mount or relative to the inner core of the rear rubber mount, marking (a).
- Apply mark (b) offset by 90° to stop plate on front rubber mount or to inner core of rear rubber mount.
- Tighten bolt to 90° angle, 2nd stage. Marking (a) and marking (b) must then match.
Shown on left front rear-axle suspension