Remove/install fire extinguishing system temperature sensor - AR86.10-P-0102MBD
MODEL 220.1 /8 as of 15.4.04 with CODE (Z04) Light armoring with CODE (Z07) Top protection with fire extinguishing system, rear fire extinguishing system temperature sensor
Fig 1: Identifying Rear Fire Extinguishing System Temperature Sensor Remove/Install Components - Shown On Model 220.1
Shown on model 220.1
| Remove/install | |||
| Danger of actuating fire extinguishing system when the work sequence is not observed. | |||
| 1 | Switch off ignition, detach transmitter key from electronic ignition switch control unit | ||
| 2 | Remove fuses no. 54 and no. 58 in rear fuse and relay module | ||
| Fuse assignment of rear fuse and relay box | GF54.15-P-1256-01MB | ||
| 3 | Remove rear seat cushion | Model 220.1 with code (223) Electrically adjustable rear bench seat or Model 220.875/878 with Vis-a-vis seats | AR91.12-P-1020M |
| Model 220.1 without code (223) Electrically adjustable rear bench seat or without code (224) Electrically adjustable individual rear seats, with seat ventilation, seat heater and memory package | AR91.12-P-1020MA | ||
| Model 220.1 with code (224) Electrically adjustable individual rear seats, with seat ventilation, seat heater and memory package | AR91.12-P-1020MB | ||
| 4 | Expose rear fire extinguishing system temperature sensor connector (B65/1x1) and disconnect | ||
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer. | AS00.00-Z-0010-01A | |
| 5 | Raise vehicle | ||
| 6 | Loosen bolt (1) and remove bracket (2) with rear fire extinguishing system temperature sensor (B65/1) | ||
| 7 | Install in the reverse order | ||
| 8 | Perform self-test for fire extinguishing system | AR86.10-P-0101-01MB |