Remove/install the end cover - AR01.40-P-8913MC

ENGINE 275 in MODEL 215, 216, 220, 221, 230 

Fig 1: Identifying End Cover Remove/Install Components

	Remove/install
1	Remove automatic transmission	Model 215, 220	AR27.10-P-0500I
		Model 230	AR27.10-P-0500RC
		Model 216, 221	AR27.10-P-0500SZ
2	Dismount flywheel/drive plate (1)	Model 215, 216, 220, 221	AR03.30-P-8001MC
		Model 230	AR03.30-P-8001R
3	Remove end cover (2)	Pry off end cover (2) carefully at both marked points (arrows) using a slanted screwdriver. The crankshaft sealing ring (3) must always be replaced when end cover (2) is removed. Pay attention to the fitted sleeves when pressing on end cover (2). End cover (2) is made out of magnesium alloy. Installation:  Observe application of sealant to end cover (2): ↓
		Information on application of sealant to end cover of crankcase	AH01.40-P-1000-04A
			Figure
		Make sure that no sealant enters the oil ducts, otherwise this can lead to engine damage.	*BA01.40-P-1004-01C
		Sealant	*BR00.45-Z-1013-01A
4	Replace front crankshaft radial seal (3)	The rear crankshaft radial sealing ring (3) must only be removed once the end cover (2) has been taken off. Installation:  Circumference and lip of crankshaft radial sealing ring (3) as well as counter tread on crankshaft must be free of oil and grease.
		Model 215, 216, 220, 221	AR03.20-P-3063MC
		Model 230	AR03.20-P-3063R
5	Install in the reverse order

CRANKCASE, TIMING CASE COVER, END COVER

Number	Designation			Engine 275, 285
BA01.40-P-1004-01C	End cover screw	Thread not pretapped	Nm	-
		Thread pretapped	Nm	8

Fig 2: Identifying Squeeze Gun (112 589 00 25 00)

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1013-01A	Sealant	A 003 989 98 20