Electronic stability program (ESP) is activated even in slight curves at moderate speed - AF42.45-P-3100B

MODEL 202, 208 with ENGINE 111 

MODEL 202 with ENGINE 605, 611 

MODIFICATION NOTES

3.5.00

Supersedes STIP 42.45-013 dated 10.05.2000

Damage code	Cause	Remedy
	The electronic stability program (ESP) starts regulating too early.	Only control modules with part number 202 545 47 32 and Q status 06 (imprint on control module "Q06") installed since the end of February 2000 are affected.
	This can occur particularly in long curves (e.g. freeway exits). This means that the customer already notes control noises or flashing indicator lamp (regulation > 0.8 s) without the vehicle over-steering noticeably.	Control modules with Q status "Q05" or smaller are not affected!
		1 Remove, install, replace control module. Install control module with "Q7" or higher. GLC only has parts in stock with Q status "Q07" or higher.

PARTS ORDERING NOTES

Part no.	Designation	Quantity
202 545 49 32/05	Repair kit for control module	as req.