Checking vehicle level at front and rear axles - AR40.20-P-0300C

MODEL 210.00 /01 /02 /03 /04 /05 /06 /07 /20 /21 /22 /23 /24 /26 /27 

Fig 1: Measuring Device Between Retaining Bolts Of Wishbone Bearing - Model 210.00 /01 /02 /03 /04 /05 /06 /07 /20 /21 /22 /23 /24 /26 /27

Fig 2: Measuring Device On Inside Of Spring Control Arm - Model 210.00 /01 /02 /03 /04 /05 /06 /07 /20 /21 /22 /23 /24 /26 /27

	Checking
1	Observe general information on chassis alignment.	Following repair work forcefully move vehicle up and down several times before measuring.	AR40.20-P-0201A
2	Check vehicle level at the front axle.	Insert measuring device (01) between the retaining bolts of the wishbone bearing.	Fig 3
		Position contact arm of measuring device (01) on transverse control arm and read off vehicle level value measured from center of vehicle.	*BE40.20-P-1001-02D
3	Check vehicle level at the rear axle  .	Place the swivel arm of the measuring device (02) on the inside of the spring control arm.	Figure
		Position contact arm on the rear axle shaft and read off the plumb value of vehicle level, viewed from the center of the vehicle.	*BE40.20-P-1001-03D
		Vehicle level at front or rear axle outside tolerance↓.
		Adjust vehicle level by changing the springs or spring rubber mounts.	AR40.20-P-0300-01B
		Check function of level control. If OK, adjust the vehicle level by changing the spring or spring rubber mount.
		On vehicles with level control  a vehicle level too low should not  be corrected by changing the level control connection rod (control point).

Fig 3: Identifying Measuring Device (210 589 01 21 00)

Fig 4: Identifying Measuring Device (201 589 01 21 00)