Removing and installing control unit for sliding roof drive - AR77.20-P-1850E
MODEL 202 up to 31.5.97 with CODE (412b) Electrically operated tilting/sliding roof with CODE (414a) Electrically operated glass tilting/sliding roof
MODEL 210 up to 28.2.97 with CODE (414a) Electrically operated glass tilting/sliding roof
| Removal | |||
| 1 | Close tilting/sliding roof | ||
| 2 | Remove front dome lamp (E15/2) | Model 202 | AR82.20-P-0110E |
| Model 210 | AR82.20-P-0110F | ||
| 3 | Remove sliding roof drive | AR77.20-P-1800E | |
| 4 | Unscrew screw (2) in control unit (1) | ||
| 5 | Unclip catches (arrows) | ||
| 6 | Pull off control unit (1) | ||
| Installation | |||
| 1 | Turn punched triangle (5) on control gear (4) to coincide with punched triangle (6) on gear housing (3) with help of Allen wrench (12 o'clock position). | ||
| 2 | Press on control unit (1) | ||
| 3 | Screw in screw (2) | ||
| 4 | Connect sliding roof drive | ||
| 5 | Press tilting/sliding roof switch (S13/2) forward in closing direction until sliding roof motor stops running | ||
| 6 | Install sliding roof drive | AR77.20-P-1800E | |
| 7 | Install front dome lamp | Model 202 | AR82.20-P-0110E |
| Model 210 | AR82.20-P-0110F | ||
| 8 | Check for proper function |