Removing and installing engine hood lock release cable - AR88.40-P-3100E

MODEL 202 

MODIFICATION NOTES

27.7.00

Greasing or lubricating engine hood lock no longer permissible

Step 10

Fig 1: Identifying Engine Hood Lock Release Cable Remove/Install Components - MODEL 202

	Removing, installing
1	Open engine hood	Position engine hood to upright position	AR88.40-P-1000E
2	Unscrew screw (1) from handle (3)
3	Pull handle (3) out of cover catch and unhook engine hood lock release cable (5) from handle (3)
4	Remove cover below instrument panel		AR68.10-P-1500E
5	Press pull grommet (4) in fuse box (6, arrow) back from inside	When installing pull grommet ensure that fuse box is seated properly.
6	Fasten cord or wire on pull nipple of engine hood lock release cable (5) at inside	Facilitates assembly
7	Remove cover (7) in left engine compartment
8	Unclip clips (8) from upper frame cross member
9	Remove lock cover (9)	Vehicles with air conditioning: Removing and installing front end cross member
10	Unhook engine hood lock release cable from engine hook lock (10)
11	Unclip engine hood lock release cable (5) from safety hook (6) and pull out toward front.
12	Install in the reverse order	When installing ensure that engine hood lock release cable is routed properly.
13	Perform function check