Electrical System, Equipment & Instructions -- 129 Chassis
- General Information
- Basic Knowledge
- CAN data bus, function - GF54.00-P-0005A
- Fuse and relay box, build condition - GF54.15-P-0800CS
- Fuse and relay box, fuse assignment relay holder - GF54.15-P-1255-18CS
- Bulb failure indicator light, function - GF54.15-P-1520CS
- Instrument cluster (IC), function - GF54.30-P-0002A
- Charge indicator lamp, exterior lamp failure - GF54.30-P-3007A
- Instrument/display illumination, location/task/function - GF54.30-P-3008A
- Safety Precautions
- Testing & Repair
- Testing and repair work: Passenger cars: Electrical system, equipment and instruments - AR54.00-Z-9129AA
- Disconnect/connect battery's ground cable - AR54.10-P-0003A
- Removing and installing battery - AR54.10-P-0005EA
- Treatment of battery if vehicle taken out of service - AR54.10-P-0006EA
- Check quiescent current consumption - AR54.10-P-1030AB
- Notes
- Preparing test with quiescent current retention device - AR54.10-P-1030-01AB
- Preparing test without quiescent current retention device - AR54.10-P-1030-02AB
- Testing quiescent current - AR54.10-P-1030-03AB
- Testing quiescent current - AR54.10-P-1030-03CS
- Determining circuit with increased quiescent current consumption - AR54.10-P-1030-04AB
- Determining circuit with increased quiescent current consumption - AR54.10-P-1030-04CS
- Establishing unfused components with excessive quiescent current consumption - AR54.10-P-1030-06AB
- Check battery; - AR54.10-P-1129-01A
- Charge battery - AR54.10-P-1130Z
- Removing and installing fuse and relay box - AR54.15-P-1255
- Removing and installing relays and control modules - AR54.15-P-1300CS
- Removing and installing daytime running lamp relay - AR54.15-P-9998CS
- Repairing wiring harness using soldered terminal sleeve - AR54.18-P-0100-02A
- Repair supplemental restraint system (SRS) squib wiring harness - AR54.18-P-0600A
- Removing and installing control module box - AR54.20-P-1257CS
- Removing and installing blower motor for module box - AR54.20-P-2350CS
- Removing and installing blower motor for control module box - AR54.20-P-2351CS
- Removing, installing module box - AR54.20-P-2360CS
- Flashing control unit - AR54.21-P-0012-06A
- Removing and installing combination switch - AR54.25-P-2800CS
- Removing and installing switch in center console - AR54.25-P-3190CS
- Removing and installing instrument cluster - AR54.30-P-6015EA
- Removing and installing instrument cluster housing - AR54.30-P-6031CS
- Removing and installing electronic plate - AR54.30-P-6040CS
- Removing and installing bulbs in instrument cluster - AR54.30-P-6049CS
- Checking exterior lamp failure indicator - AR54.30-P-6070CS
- Removing and installing display instruments in instrument cluster - AR54.30-P-6111CS
- Removing and installing outside temperature sensor - AR54.30-P-6341
- Repair & Adjustments
- Function of trip computer - RA54001070415X(54-415)
- Information for troubleshooting - RA54001070418X(54-418)
- Checking function of trip computer - RA54001070420X(54-420)
- Adapting fuel consumption display - RA54001070424X(54-424)
- Removing and installing trip computer keyboard - RA54001070430X(54-430)
- Removing and installing trip computer control unit with display, models 129 and 140 - RA54001070433X(54-433)
- Renewing bulbs in keyboard and display unit - RA54001070439X(54-439)
- Miscellaneous Notes