Remove/install radius rod - AR35.20-P-0111A

MODEL 140 

Fig 1: Identifying Radius Rod Components

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

MODIFICATION NOTES

2.5.07	Self-locking nut, strut rod to rear axle carrier, M14		*BA35.20-P-1001-03A
25.5.07	Self-locking nut, torque strut to wheel carrier, M16		*BA35.20-P-1002-03A

Figure item, etc.	Work instructions
	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between the four columns of the vehicle lift and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer	AS00.00-Z-0010-01A
Installation	Replace self-locking nuts
	Remove, install fixed brake caliper		AR42.10-P-1600DM
	Remove/install brake disc		AR42.10-P-0220A
3	Torque strut	Installation:  The rear axle shaft must be horizontal when tightening the nuts
		Torque strut to wheel carrier	*BA35.20-P-1002-03A
		Torque strut to rear axle carrier	*BA35.20-P-1001-03A
3b	Mark eccentric disks	in relation to rear axle carrier (arrow). Installation:  Install disks with notch(es) at the back  and disks with number and letter at the front  in the direction of travel Eccentric washer offset 1 mm per notch, or on washers with number and letter corresponding to the number (e.g. 1 mm at 1N  ). Observe technical modifications: ↓
		Rear axle shaft diameter increased	BT35.20-P-9404-01A
3e	Fit-bolt	Installation:  Install new fitted bolt

TORQUE STRUT

Number	Designation			Model 140
BA35.20-P-1001-03A	Self-locking nut, tension arm to rear axle carrier	M12	Nm	70
		M14	Nm	120
BA35.20-P-1002-03A	Self-locking nut, torque strut to wheel carrier	M12	Nm	70
		M16	Nm	230