Replacing rubber mount of front axle carrier (front axle removed) - AR33.10-P-0110A

MODEL 140 

Fig 1: Identifying Front Axle Carrier, Rubber Mount, Pulling-In Tool And Pressing-Out Tool

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Removal
1	Using pressing-out tool (046) and two-arm puller, press rubber mount out of front axle carrier (1)		Fig 3
			Fig 2
	Installation
2	Coat periphery of rubber mount with naphthalene	Do not use oil or grease	*BR00.45-Z-1002-06A
3	Using the centering pin (arrow) of the pulling in tool (045), align new rubber mount (1a) with front axle carrier and pull in.	The installed position is identified by a half-moon shaped recess. Observe installation markings "F" (for front rubber mount) and "R" (for rear rubber mount).	Fig 4

Fig 2: Identifying Puller (000 589 88 33 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 3: Identifying Pressing-Out Tool (140 589 07 33 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 4: Identifying Pulling-In Tool (140 589 08 33 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1002-06A	Lubricant	A 000 989 01 60