  |
Remove/install |
|
|
 |
Risk of death
caused by vehicle slipping or toppling off of the lifting platform. |
Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer. |
AS00.00-Z-0010-01A |
 |
Notes on self-locking nuts and bolts |
|
AH00.00-N-0001-01A |
| 1.1 |
Remove engine compartment paneling |
Vehicles with gasoline engines |
|
| 1.2 |
Remove bottom section of soundproofing |
Vehicles with diesel engines |
ra94001405305x |
| 2 |
Detach steering damper (46) from drag link |
 |
*BA46.40-P-1001-03A |
| 3 |
Unscrew nuts on drag link (11) |
Counter the ball pin using an Allen wrench if necessary. |
|
| |
|
 |
*BA46.40-P-1001-04A |
| 4 |
Install thrust piece (051) |
 |
Fig 3 |
| 5 |
Press drag link (11) off steering gear pitman arm and steering idler arm using puller (050) |
Installation:
Clean grease off tapers and press the ball joints of the drag link securely into the steering arms. |
|
| |
|
 |
Fig 4 |
| 6 |
Check joints of drag link (11) for play and damaged rubber boots |
Replace drag link (11) if necessary. |
|
| |
|
The left drag link joint is a pivot joint with a swivel range of max. 2°. This prevents pivot movements of the drag link. |
|
| 7 |
Install in the reverse order |
|
|
| 8 |
Check front wheel toe and adjust if necessary |
See: ↓ |
|
| |
|
Perform a wheel alignment check |
AR40.20-P-0200A |