Remove and install the reveal molding at the side of the windshield - ra68001400405x(0405)

Model 140 - A. Sedan, B. Coupe

Sedans

Fig 1: Identifying Reveal Molding At Side Of Windshield Components

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Edge protector	remove in area of molding on A-pillar.
Molding (Fig 1)	slide up and press off of clamps with plastic wedge.
Molding (Fig 2)	slide down toward inside and pull out of panelling at top.
Reinstall	in opposite order.

Cover (arrows) on handle (1)	press off and screw off handle.
Panelling on rear pillar (2) in front area	unclip at reveal molding (3) and roof frame.

Fig 2: Identifying Reveal Molding At Side Of Windshield (Coupes) Components

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Reveal molding (3)	pull out of retaining clips (5 each) on A-pillar (arrows) and remove upward, simultaneously pivot out below rear pillar panelling (2).
When reinstalling	insert clips (5 each) on A-pillar.
Reveal molding (3)	align on A-pillar and press into clips (5 each).
Plastic clips (arrow) on rear pillar panelling (2)	connect with reveal molding (3) and clip rear pillar panelling (2) onto roof frame.
Handle (1)	screw on and press on covers (arrows).
Plush lip on sealing frame (4)	pry over reveal molding (3) and rear pillar panelling (2).