Installing control module - AZ54.65-P-0001-04I
Model 163.1 without code 849
The installation described below is not binding and only represents a possible installation example. The choice of installation point depends on the vehicle equipment. If possible the installation point should be selected so that the control module can be installed with the connection point at the bottom.
- Attach the control module (3) to the right side panel of the loading space and mark the control module mounting holes on the front side of the side panel.
- Drill through the marked drilling points to 6.5 mm dia.
- Screw the control module (3) onto the side panel with 2 screws (1), spacer sleeves (2) and nuts (4).