LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 1999 >> E430 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Overall Vehicle -- Self-Diagnostic System -- 210 Chassis >> Self-Diagnostic System >> Extended vehicle network (EVN) diagnosis fault memory wiper system (B1000, B1010, B1011, B1057, B1059, B1141, B1142, B1217, B1483, B1484, B1643, B1729)- AD00.19-P-4000A

Extended vehicle network (EVN) diagnosis fault memory wiper system (B1000, B1010, B1011, B1057, B1059, B1141, B1142, B1217, B1483, B1484, B1643, B1729)- AD00.19-P-4000A

MODEL 202 as of 1.6.97, 208, 210.081 /281, 210 as of 1.3.97 

  Extended vehicle network (EVN) diagnosis, previous knowledge   AD00.19-P-2000A 
I Fuses in order.    
II Ignition: ON    
III Connect Hand-Held Tester to data link connector (DTC readout) (X11/4) in accordance with connecting diagram   AD00.00-P-1000AZ 
IV Voltage supply of control modules and CAN data buses in order   AD00.19-P-6000A 
V All CAN data buses must be connected    
  Fault memory     
Fault code HAND-HELD TESTER Possible cause  Notes  Remedy 
B1000 Electronic ignition switch control module (N73)  
  • Replace N73
B1000 Overhead control panel control module (N70)  
  • Replace N70
B1000 Driver-side signal-acquisition and actuation module (SAM) (N10/1)  
  • Replace N10/1
B1010 Undervoltage   AD00.19-P-6000-01A 
AD00.19-P-6000-02A 
AD00.19-P-6000-03A 
AD00.19-P-6000-04A 
AD00.19-P-6000-05A 
AD00.19-P-6000-06A 
AD00.19-P-6000-07A 
AD00.19-P-6000-08A 
AD00.19-P-6000-09A 
AD00.19-P-6000-10A 
AD00.19-P-6000-11A 
B1011 Overvoltage   AD00.19-P-6000-01A 
AD00.19-P-6000-02A 
AD00.19-P-6000-03A 
AD00.19-P-6000-04A 
AD00.19-P-6000-05A 
AD00.19-P-6000-06A 
AD00.19-P-6000-07A 
AD00.19-P-6000-08A 
AD00.19-P-6000-09A 
AD00.19-P-6000-10A 
AD00.19-P-6000-11A 
B1057 CAN: Communication between electronic ignition switch control module (N73) and overhead control panel control module (N70) faulty   AD00.19-P-6000-30A 
AD00.19-P-6000-30B 
AD00.19-P-6000-30C 
AD00.19-P-6000-31A 
AD00.19-P-6000-31B 
AD00.19-P-6000-31C 
AD00.19-P-6000-32A 
AD00.19-P-6000-33A 
AD00.19-P-6000-33B 
AD00.19-P-6000-34A 
AD00.19-P-6000-35A 
AD00.19-P-6000-45A 
AD00.19-P-6000-45B 
AD00.19-P-6000-45C 
AD00.19-P-6000-46A 
AD00.19-P-6000-46B 
AD00.19-P-6000-46C 
AD00.19-P-6000-47A 
AD00.19-P-6000-48A 
B1059 CAN: Communication between electronic ignition switch control module (N73) and driverside signal-acquisition and actuation module (SAM) (N10/1) faulty   AD00.19-P-6000-45A 
AD00.19-P-6000-45B 
AD00.19-P-6000-45C 
AD00.19-P-6000-46A 
AD00.19-P-6000-46B 
AD00.19-P-6000-46C 
AD00.19-P-6000-47A 
AD00.19-P-6000-48A 
B1141 HCS switch signal > 25 seconds   AD00.19-P-6000-74A 
B1142 Rear wipe/wash switch signal > 25 seconds   AD00.19-P-6000-73A 
B1217 000 Rain sensor (B38), no communication   AD00.19-P-6000-64A 
AD00.19-P-6000-65A 
AD00.19-P-6000-66A 
B1217 001 Rain sensor (B38), defective  
  • Replace B38
B1217 002 No windshield adaption  
  • Clean the windshield
  • Replace wiper rubber
  • B38
  • Replace windshield lens body
B1217 003 Excess temperature  
  • Windshield temperature > 65°C
  • Replace B38
B1217 004 Intermittent fault  
  • If it occurs frequently, replace B38
B1217 006 Wiper system not calibrated  
  • Erase fault memory
  • Perform approx. 40 wipe cycles
B1483 Actuation of windshield washer relay (K40/2k3) SHORT-CIRCUIT TO POSITIVESHORT-CIRCUIT TO GROUND (rear window)   AD00.19-P-6000-68A 
AD00.19-P-6000-69A 
AD00.19-P-6000-70A 
B1484 Actuation of windshield washer relay (K40/2k3) SHORT-CIRCUIT TO GROUND (windshield)   AD00.19-P-6000-61A 
B1643 Rain sensor, no communication   AD00.19-P-6000-65A 
AD00.19-P-6000-66A 
AD00.19-P-6000-67A 
B1729 PSE control module (combined) (A37)  
  • Replace A37