Removal and installation of electronic ignition/starter switch (EZS) - AR46.10-P-0810B

MODEL 208 

Fig 1: Identifying Electronic Ignition/Starter Switch Remove/Install Components (1 Of 3)

Fig 2: Identifying Electronic Ignition/Starter Switch Remove/Install Components (2 Of 3)

Fig 3: Identifying Electronic Ignition/Starter Switch Remove/Install Components (3 Of 3)

	Removal, installation
1	Remove cover below instrument panel		AR68.10-P-1500K
2	Unscrew screw from bottom right of instrument panel
3	Unscrew escutcheon (36a) from instrument panel using a claw-type wrench (020)		Fig 4
4	Remove electronic ignition/starter switch (N73)	Installation:  Shift lock (36h) points to the top left
5	Remove shift lock (36h), by compressing the retaining clips (arrows) and moving the shift lock forwards out of the retaining lugs
6	Disconnect electrical connectors
7	Install in reverse order

Fig 4: Identifying Claw-Type Wrench For Escutcheon On Ignition/Starter Switch (210 589 00 07 00)