Removing and installing pushbutton control module for automatic heater or air conditioning (Tempmatic) - AR83.25-P-1120K

MODEL 208 

Fig 1: Identifying Pushbutton Control Module For Automatic Heater Or Air Conditioning (Tempmatic) Remove/Install Components (1 Of 3)

Fig 2: Identifying Pushbutton Control Module For Automatic Heater Or Air Conditioning (Tempmatic) Remove/Install Components (2 Of 3)

Fig 3: Identifying Pushbutton Control Module For Automatic Heater Or Air Conditioning (Tempmatic) Remove/Install Components (3 Of 3)

	Removal, installation
1	Unclip cover panel (1) (arrows), pivot up and remove	Do not disconnect electrical connectors
2	Unscrew screws (2)
3	Pull pushbutton control module (N18 or N19/1) out toward rear
4	Disconnect connector (4)	When disconnecting the connector tilt retaining strap down
5	Remove pushbutton control module (N18 or N19/1)	Installation:  When installing first insert left air distribution linkage, then right air distribution linkage, then slide in A/C pushbutton control module until it catches. When replacing the A/C pushbutton control module version coding is required.
6	Reinstall in opposite order