Remove and install generator - AR15.40-P-5032EB

ENGINE 112.910 /920 in MODEL 202

ENGINE 112.940, 113.943 /984 in MODEL 208

Shown on ENGINE 112

Fig 1: Identifying Generator Remove/Install Components - Shown On Engine 112

G04715176

MODIFICATION NOTES

14.4.00	Specification revised from 15 Nm to 18 Nm	Specification in BA15.40-P-1001-01A revised for Series 112, 113 engines	*BA15.40-P-1001-01A
14.4.00	Value changed from 4 Nm to 5 Nm	Value in BA15.40-P-1002-01A changed in engine 112, 113	*BA15.40-P-1002-01A

	Removal/installation
1	Disconnect battery ground line	Insulate cable lug of ground line to provide protection from unintentional contact of disconnected ground line.	AR54.10-P-0003A
2	Remove bottom engine compartment panel	Model 202 Model 208	AR61.20-P-1105A
3	Remove ribbed V-belt	Engine 113.943 in Model 208	AR13.22-P-1202B
		Engine 112.910/920 in model 202	AR13.22-P-1202BA
		Engine 112.940, 113.984 in Model 208
4	Disconnect electrical line circuit 30 (B+)(1) and electrical line circuit 61(D+) (2).		*BA15.40-P-1001-01A
			*BA15.40-P-1002-01A
5	Unscrew alternator screws (3)		*BA15.40-P-1003-01A
6	Remove alternator (G2) downwards
7	Install in the reverse sequence

TORQUE SPECIFICATION

GENERATOR

Number	Designation		Engine 112.91/92/94/ 953/954/955/ 96/97, 113.94/96/98
BA15.40-P-1001-01A	Nut of circuit B+ to generator	Nm	18
BA15.40-P-1002-01A	Nut of circuit D+ to generator	Nm	5
BA15.40-P-1003-01A	Screw, alternator	Nm	42