Removing and installing windshield molding - AR67.10-P-1200K

MODEL 208 

Illustrated on model 208.3 

Fig 1: Identifying Windshield Molding Remove/Install Components

	Removal
1	Remove paneling on outside of A-pillar	Remove paneling on outside of A-pillar only on one side	AR88.80-P-8500K
2	Lift molding (1) at side with plastic wedge (arrow) and pull out of clip-type fasteners (2, 5 each)		Fig 2
	Installation
3	Install molding (1) on clip-type fasteners (2, 5 each), align at side and press down
4	Install paneling on outside of A-pillar		AR88.80-P-8500K

Fig 2: Identifying Long Wedge (115 589 03 59 00)