Removing and installing molding on rear side window - AR67.30-P-4010K
MODEL 208.3
| Removal | |||
| 1 | Open front door | ||
Avoid damaging paint, do not use metal tools with sharp edges |
|||
| 2 | Slide cover (2) forwards until separation joint is free | Fig 2 | |
| 3 | Press molding (1) off of clips (4) with installation wedge (arrow) | Fig 2 | |
| 4 | Remove molding (1) | ||
| Installation | |||
| 5 | Check clips (4, 6 each) | ||
| 6 | Position molding (1) with rubber gasket on clips (4), align and press on | ||
| 7 | Slide cover (2) over separation joint | ||
| 8 | Check position of gasket on molding (1), correct, if necessary | ||
| 9 | Close front door |