Removing and installing rear bumper - AR88.20-P-2200K

MODEL 208 

Fig 1: Identifying Rear Bumper Remove/Install Components

	Removal, installation
1	Remove cover on rear center piece
2	Unscrew screws (2)	Press paneling at side of trunk to side
			*BA88.20-P-1005-01A
3	Unscrew nuts (3)		*BA88.20-P-1002-01A
4	Open rotary clip (7) on fender flange on side and remove bumper
5.1	Transfer AMG bumper	See Installation instructions for accessories ↓
		Retrofit AMG paneling parts, model 208.3 coupe	AZ88.00-P-0001B
		Retrofit AMG paneling parts, model 208.4 convertible	AZ88.00-P-0001D
6	Install in opposite order	When installing, slide guide (4) onto mount (5)

BUMPER

Number	Designation		Model 208.3/4
BA88.20-P-1002-01A	Nut for rear bumper on rear center section	Nm	8
BA88.20-P-1005-01A	Bolt with sealing disc for rear bumper on fender at side	Nm	5