Removing, installing ATA alarm signal siren - AR80.50-P-9840E

MODEL 202, 208 as of 1.6.98 with CODE (551a) Anti-theft alarm (ATA) 

Shown on model 202 

Fig 1: Identifying ATA Alarm Signal Siren Remove/Install Components

	Removal, installation
1.1	Remove left front wheel-housing liner	Model 202
1.2	Remove trim panel between bumper and left front wheel-housing liner	Model 208
2	Disconnect connection (2) of alarm signal siren (H3/1)	Before disconnecting the siren, ensure that the anti-theft alarm system (ATA) has been deactivated, otherwise the siren will be triggered. (Internal voltage supply from rechargeable battery)
3	Remove bolt (1), remove alarm signal siren (H3/1).
4	Install in reverse order