Removing and installing front door IR receiver - AR80.30-P-4305F

MODEL 202 as of 1.6.97, 208, 210 as of 1.3.97 

1. Rubber door seal
2. Allen wrench
3. Electrical connector

   A26/1 Left front door IR receiver

   A26/2 Right front door IR receiver

Illustrated on model 208 

Fig 1: Identifying Front Door IR Receiver Remove/Install Components

	Removal, installation
1	Pull rubber door seal (1) out in area of door lock
2	Unscrew mounting screw for IR receiver with Allen wrench (2, 4 mm)
3	Carefully remove left front door IR receiver (A26/1) or right front door IR receiver (A26/2).
4	Disconnect electrical connector	When installing ensure that wires are routed correctly and electrical connector is properly clipped in.
7	Reinstall in opposite order