| 1 |
Open crank window |
|
|
| 2 |
Unclip mirror triangle cover (2) from above using assembly wedge, pull upwards and remove |
 |
Fig 2 |
| 3 |
Unclip entrance lamp (3), disconnect electrical connection and remove entrance lamp |
|
|
| 4 |
Unclip wooden surround (4) on the front side (arrow) with extractor hook, push forwards and remove. |
 Installation:
Ensure that the rotating bars are horizontal.
|
Fig 3 |
| 5 |
Disconnect switch group connectors |
|
|
| 6 |
Unscrew screws (5) in the area of the front door handle |
|
|
| 7 |
Unclip cover (6) on armrest and unscrew screw (7) |
|
|
| 8 |
Unclip SRS cover (8) and unscrew screw (9) |
With code 292 (front side airbag) |
|
| 9 |
Detach lock escutcheon (10) |
|
|
| 10 |
Press door lining (1) on the inner door panel at bottom, front and rear using assembly wedge |
Guide each assembly wedge straight to the clips. |
Fig 2 |
| 11 |
Lift door lining (1) out of retaining clips at the top of the sealing rail using assembly wedge and at the same time pull away from the inner door panel |
Installation:
Guide entrance lamp electrical connection through the recess in the door lining |
Fig 2 |
| 12 |
Unhook control cable (11) on interior door control |
|
|
| 13 |
Remove door lining (1) and put down on clean base |
|
|
| 14 |
Check film and clips on inner door panel and replace if necessary. |
Stick door film onto inner door panel. |
*BR00.45-Z-1004-02A |
| 15 |
Check clips on door lining (1) and replace if necessary. |
|
|
| 16 |
Install in reverse order |
|
|