Removing and installing rear damper valves - AR32.32-P-0680A

MODEL 140 as of 1.6.94, 210 with CODE (217a) Level control at rear axle with ADS

Model 140

Fig 1: Identifying Rear Damper Valves Components (Model 140)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Model 210

Illustration shows arrangement of model 210.0

Fig 2: Identifying Rear Damper Valves Components (Model 210)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig. item, etc.	Work instructions
	Risk of injury to skin or eyes from hydraulic fluid spraying out under pressure. Risk of poisoning from swallowing hydraulic fluid.	Render the hydraulic system pressureless before commencing work on system. Wear protective clothing and eye protection.	AS00.00-Z-0013-01A
Installation	Replace self-locking nuts and bolts
	Drain pressurized oil system, fill		AR32.30-P-0630A
P4	Pressure lines	Disconnect at the damper valves (Y53, Y54).
			*BA32.32-P-1001-02A
Y53, Y54	Damper valve	Detach at bracket, disconnect electrical connector.
			*BA32.32-P-1002-02A
			*BA32.32-P-1003-02A
			*BA32.32-P-1004-02A

Damper valve rear axle

Number	Designation			Model 140 with ADS as of 1.6.94	Model 210 with ADS
BA32.32-P-1001-02A	Pressure line of ADS to damper valve (reference value)	M16 x 1.5	Nm	30	30
BA32.32-P-1001-02A	Pressure line of ADS to damper valve (reference value)	M18 x 1.5	Nm	44	44
BA32.32-P-1002-02A	Self-locking bolt of left damper valve to bracket	M8	Nm	24	-
BA32.32-P-1003-02A	Self-locking nut of right damper valve to bracket	M8	Nm	14	14
BA32.32-P-1004-02A	Self-locking nut of left damper valve to bracket	M8	Nm	-	14