Pressing ABS gear onto drive pinion Press-on sleeve for ABS gear - AR35.31-P-0550-31B
Number of teeth on ABS gear: ↓
Characteristics, installation survey for rear axle center assemblies with 168 mm dia. crown wheel
Characteristics, installation survey for rear axle center assemblies with 185 mm dia. crown wheel
Characteristics, installation survey for rear axle center assemblies with 210 mm dia. ring gear
| AR35.31-P-0550-31B | Pressing ABS gear onto drive pinion | ||
| Press-on sleeve for ABS gear | WF58.50-P-3531-04B | ||
| Number of teeth on ABS gear: ↓ | |||
| Characteristics, installation survey for rear axle center assemblies with 168 mm dia. crown wheel | GF35.31-P-1000-01B | ||
| Characteristics, installation survey for rear axle center assemblies with 185 mm dia. crown wheel | GF35.31-P-1000-01C | ||
| Characteristics, installation survey for rear axle center assemblies with 210 mm dia. ring gear | GF35.31-P-1000-01D |
Press ABS gear (49) with shop-made spacer sleeve (013) onto drive pinion (47).
The number of teeth on the ABS gear (49) must correspond with the rear axle ratio.