Deployment of removed airbag units - AR91.60-P-0611-02A

AR91.60-P-0611-02A	Deployment of removed airbag units
	Risk of injury.  Injuries may result when performing testing or repair work on airbag or emergency tensioning retractor units.	Store airbag unit with expulsion area on top, do not subject to temperatures above 100°C. When working on these units, disconnect the power supply.	AS91.00-Z-0001-01A
	Risk of injury.  Injuries may result when performing testing or repair work on airbag or emergency tensioning retractor units.	Models 124, 129 up to 30.6.93, 140, 202 up to 30.6.93 Store airbag unit with expulsion area on top, do not subject to temperatures above 100°C. When working on these units, disconnect power supply and unplug the SRS test connector (X11/13).	AS91.00-Z-0001-01B
	Notes on controlled deployment of airbag, side airbag and emergency tensioning retractor units	Models 163, 168, 170, 202, 203, 208, 209, 210, 215, 220, 230, 240, 414, 461, 463	AH91.60-P-0611-02P
	Notes on disposal of airbags and emergency tensioning retractors	All models	OS91.00-P-0001-01A

Fig 1: Identifying Pressure Switch, Rotary Switch, Indicator Lamp And Plug Connector

Using the deployment device 

1. Plug the 2-pin plug connector (8) into the unit to be scrapped.
2. Dial the rotary switch (4) to position "1".
3. Press the battery control pressure switch (2) and deployment pressure switch (3) simultaneously.
4. For airbag units with 2 squibs, both must be deployed. To do this, repeat steps  1 through  3 after plugging the ignition cable into the second squib.

   Keep a distance of 10 meters for safety.

   After a successful deployment, the deployment indicator light (5) flashes.