Deployment of airbag units when no deployment device is present - AR91.60-P-0611-05A

AR91.60-P-0611-05A	Deployment of airbag units when no deployment device is present
	Risk of injury.  Injuries may result when performing testing or repair work on airbag or emergency tensioning retractor units.	MODELS 163, 170, 202 as of 1.7.93, 208, 210, 414, 463 Store airbag unit with expulsion area on top, do not subject to temperatures above 100°C. When working on these units, disconnect the power supply.	AS91.00-Z-0001-01A
	Risk of injury.  Injuries may result when performing testing or repair work on airbag or emergency tensioning retractor units.	MODEL 202 up to 30.6.93 Store airbag unit with expulsion area on top, do not subject to temperatures above 100°C. When working on these units, disconnect power supply and unplug the SRS test connector (X11/13).	AS91.00-Z-0001-01B
	Notes on controlled deployment of airbag, side airbag and emergency tensioning retractor units	Models 163, 168, 170, 202, 203, 208, 210, 215, 220, 414, 463	AH91.60-P-0611-02P
	Ignition cable for firing airbag and seat belt tensioner units		WF58.50-P-9160-02A
	Notes on disposal of airbags and emergency tensioning retractors	All models	OS91.00-P-0001-01A

Application of shop-made ignition cables 

1. Make up ignition cable of min. 10 m length with pressure switch.
2. Plug the 2-pin plug connector into the corresponding airbag unit.
3. Connect ignition cables to the battery.
4. Press both pressure switches simultaneously.
5. For airbag units with 2 squibs, both must be deployed. To do this, repeat steps  2 through  4 after plugging the ignition cable into the second squib.

   Keep a distance of 10 meters for safety.