Pressing in centering sleeve - AR41.10-P-0200-03DI
TEST VALUES OF PROPELLER SHAFT CENTERING SLEEVE
| Number | Designation | Model 202.078 with 6-speed manual transmission | Model 202.080 with 6-speed manual transmission | Models 202.082/085 with 6-speed manual transmission | ||
|---|---|---|---|---|---|---|
| BE41.10-P-1001-02I | Press-in distance "a" from end face of centering sleeve on propeller shaft flange | Front propeller shaft | mm | 24.9 | 24.9 | 26.8 |
| Rear propeller shaft | mm | 24.9 | 24.9 | 26.8 | ||
| Figure see | AR41.10-P-0200-03DI | AR41.10-P-0200-03DI | AR41.10-P-0200-03DI | |||
TEST VALUES OF PROPELLER SHAFT CENTERING SLEEVE
| Number | Designation | Model 202.086 with 6-speed manual transmission | Models 202.088/089 with 6-speed manual transmission | Models 202.191/193/194 with 6-speed manual transmission | ||
|---|---|---|---|---|---|---|
| BE41.10-P-1001-02I | Press-in distance "a" from end face of centering sleeve on propeller shaft flange | Front propeller shaft | mm | 24.9 | 26.8 | 26.8 |
| Rear propeller shaft | mm | 24.9 | 26.8 | 26.8 | ||
| Figure see | AR41.10-P-0200-03DI | AR41.10-P-0200-03DI | AR41.10-P-0200-03DI | |||
Press in new centering sleeve using a suitable drift punch.
Observe press-in distance "a" from end face of centering sleeve to flange.
The specified press-in distance "a" may differ depending on the thickness of the flexible disks.
The measured distance should then be taken into account before removing.