 |
Removal |
|
|
| 1 |
Pull off edge guard in area of panelling (1) |
|
|
| 2 |
Unhook retaining clips (3) from panelling (1) with screwdriver |
|
|
| 3 |
Pull panelling (1) up out of longitudinal member panelling (2) |
|
|
| 4 |
Unscrew bolt (5) on seat belt end fitting (4) |
|
|
| 5 |
Pull seat belt out of paneling (1) and put down paneling (1) |
|
|
 |
Installation |
|
|
| 6 |
Check retaining clips (3, 4 each) at top of B-pillar |
|
|
| 7 |
Guide seat belt end fitting (4) through opening in paneling (1) |
|
|
| 8 |
Insert paneling (1) into insert channel in longitudinal member paneling (2) |
|
|
| 9 |
Insert bolt (7) and pawl (6) into mount (9) and key (8) on paneling (1) |
|
|
| 10 |
Clip paneling (1) onto retaining clips (3) |
|
|
| 11 |
Screw seat belt end fitting (4) onto driver's seat with bolt (5) so that it can pivot |
 |
*BA91.40-P-1001-01A |
| 12 |
Install edge guard on B-pillar |
|
|
| 13 |
Check adjustable upper belt guide fitting on B pillar for proper function |
It should be possible to adjust and arrest the upper belt guide fitting on the B-pillar in 3 positions (top/middle/bottom) |
|