Removing and installing bulbs of headlamp unit - AR82.10-P-1201EA

MODEL 202 up to 31.8.96 

Shown on model 202 up to 31.8.96 

Fig 1: Identifying Bulbs Headlamp Remove/Install Components - Shown On Model 202 Up To 31.8.96

		Removal, installation
1	Open hood and raise to vertical position		AR88.40-P-1000E
2	Open closure clip (1)
3	Remove housing cover (2)
4	Disconnect electrical connector from corresponding bulb
5	Open relevant bulb retaining clips
6	Remove bulb	Do not grasp the glass of the bulbs with your bare fingers but use a grease-free, soft cloth. Ensure bulb is correctly installed.
7	Install in the reverse order