Removing and installing CTEL transmitter and receiver - AR82.70-P-8911E

MODEL 202.07 /08 /18 with CODE (316) MB D-network telephone (D2B) 

Illustrated on model 202 T-model 

Fig 1: Identifying CTEL Transmitter And Receiver Remove/Install Components - Illustrated On Model 202 T-Model

	Removal, installation
1	Connect quiescent current retention unit		*WH58.30-Z-1012-09A
2	Remove battery		AR54.10-P-0005EA
3	Remove side paneling in right rear		AR68.30-P-4780A
4	Unscrew screws (2)
5	Unscrew nut (5)
6	Carefully lift bracket (1) with control modules out of wheelhouse recess	Do not damage connection lines
7	Release connector from CTEL transmitter and receiver (A35) and disconnect
8	Disconnect antenna lead from CTEL transmitter and receiver (A35)
9	Loosen sheet metal screws (3) and remove mounting bracket (4)
10	Pull CTEL transmitter and receiver (A35) up and out
11	Install in opposite order