Checking and adjusting camber and caster of front wheels - AR40.20-P-0322B
MODEL 140
 |
Checking |
|
|
| 1 |
Follow general information on chassis alignment check. |
|
AR40.20-P-0201A |
| 2 |
Check vehicle level at front axle and rear axle. |
|
AR40.20-P-0300B |
| 3 |
Install measuring device for caster (04) in the fixing points on the steering knuckle. |
 |
Fig 2 |
| 4 |
Check camber and caster. |
Camber |
*BE40.20-P-1001-06A |
| |
|
Caster |
*BE40.20-P-1002-06A |
| |
Adjusting |
|
|
| 5 |
Adjust camber (front cam bolt, 19) and caster (rear cam bolt, 20) at the wishbone mount. |
The wheel spreader must not be used to adjust the toe-in. The specified value of camber or caster cannot be adjusted ↓. |
*BA40.20-P-1004-01A |
| |
|
Check upper wishbone, steering knuckle and body for accident damage and the supporting joints and follower joints for wear. |
|
TEST AND ADJUSTMENT VALUES FOR FRONT WHEEL CAMBER/CASTER
| Number |
Designation |
Model 140 up to 12/92 |
Model 140 as of 01/93 |
Model 140 suspension for increased ground clearance |
| BE40.20-P-1001-06A |
Camber |
at 0° toe-in |
- 0° 10' (-20'/ +10') |
- 0° 20' (-20'/ +10') |
- 0° (-20'/ +10') |
| BE40.20-P-1002-06A |
Caster |
at 0° toe-in |
10° 10' ± 30' |
10° 20' ± 30' |
9° 55' ± 30' |
| with wheels turned |
9° 30' ± 30' |
9° 40' ± 30' |
9° 20' ± 30' |
CHASSIS ALIGNMENT CHECK
| Number |
Designation |
Model 140 |
| BA40.20-P-1004-01A |
Nut of cam bolt |
Nm |
180 |