Remove/install headliner - AR68.30-P-4300N
MODEL 215
| Remove/install | |||
|---|---|---|---|
| 1 | Open sliding/pop-up roof panel | ||
| 2 | Remove paneling from right (2) and left (3) A-pillar | AR68.30-P-4050M | |
| 3 | Remove paneling on C-pillar | AR68.30-P-4490N | |
| 4 | Disconnect electrical connectors (11) from headliner on bottom right in area of C-pillar | ||
| 5 | Remove rear dome lamp PTS warning display | ||
| 6.1 | Remove infrared interior monitoring transmitter/ receiver | On vehicles with code (882b) Infrared interior monitoring (only with ATA) | AR80.50-P-9820F |
| 7 | Remove right rear (4) and left rear (5) coat hanger hooks | ||
| 8 | Remove right (6) and left (7) handle | ||
| 9 | Remove right (8) and left (9) sun visor | ||
| 10 | Unclip front interior lighting | ||
| 11 | Remove overhead control panel control module | AR82.20-P-1000M | |
| 12 | Remove inside rearview mirror | AR68.40-P-0001M | |
| 13 | Disconnect rain sensor connector | ||
| 14 | Remove rail (13) from sliding roof cutout upward (arrows) | ||
| 15 | Loosen headliner (1) in rear area from Velcro strips (12) | ||
| 16 | Unhook headliner (1) in rear area of clips (10) | ||
| 17 | Completely move both seats toward front and lay down backrests | ||
| 18 | Slightly pull headliner (1) down in area of windshield | ||
| 19 | Press headliner (1) with mounting rail (14) toward front (arrows) out of sliding/pop-up roof frame guide (15) | ||
| 20 | Lower both side windows on one side of vehicle | ||
| 21 | Remove headliner (1) from vehicle | ||
| 22.1 | Prepare headliner (1) for installation. | Only when replacing headliner (1). | AR68.30-P-4305N |
| 23 | Install in the reverse order | ||
| 24 | Perform function check |