Removing and installing paneling on A-pillar - AR68.30-P-4050GC

MODEL 168 up to 28.2.01 

Fig 1: Identifying Paneling On A-Pillar Remove/Install Components - Model 168 Up To 28.2.01 (1 Of 3)

Fig 2: Identifying Paneling On A-Pillar Remove/Install Components - Model 168 Up To 28.2.01 (2 Of 3)

Fig 3: Identifying Paneling On A-Pillar Remove/Install Components - Model 168 Up To 28.2.01 (3 Of 3)

	Removing, installing
1	Remove handle (4)	For this purpose open screw covers (2) and unscrew screws (3).
2	Pull off edge guard (5) on A-pillar in area of paneling (1)
3	Carefully press paneling (1) out of retaining clips (11) with assembly wedge (6)	Move assembly wedge as close as possible to lugs (10). Installation:  Check retaining clips (11), replace is necessary.
			Figure
4	Pull paneling (1) out at top below paneling (7)
5	Unclip bottom paneling (1) at lug (8) and pull out of paneling (9)	The paneling (1) is held by insert lugs (arrows) behind the paneling (9)
6	Remove paneling (1) toward middle of vehicle
7	Install in the reverse order

Fig 4: Identifying Assembly Wedge (110 589 03 59 00)