Removing and installing headliner - AR68.30-P-4300F

MODEL 210.0 up to 1.3.97 

Fig 1: Identifying Headliner Components - Model 210.0 (1 Of 2)

Fig 2: Identifying Headliner Components - Model 210.0 (2 Of 2)

	Remove/install
1	Open tilting/sliding roof	Electric tilting/sliding roof (Code 414a)
2	Remove inside rearview mirror		AR68.40-P-0001F
3	Remove front dome lamp		AR82.20-P-0110F
4	Remove sun visors
5	Remove rear dome lamp		AR82.20-P-0113F
6	Remove edge guard from door cutout
7	Remove paneling from A-pillar		AR68.30-P-4050F
8	Remove paneling on B-pillar	Do not remove belt end fitting	AR68.30-P-4700F
9	Remove paneling on C-pillar	Do not remove belt end fitting	AR68.30-P-4490F
10	Fold down backrests of front seats
11	Position shift lever toward rear
12	Remove rail (3)	Electric tilting/sliding roof (Code 414a) Installation:  Attach clip (9) using spatula so that the headliner is not damaged.
13	Detach clip (4) in dome lamp cutout
14	Detach headliner (2) from front tilting/sliding roof frame	Electric tilting/sliding roof (Code 414a)
15	Unhook clips (7)	Electric tilting/sliding roof (Code 414a) Unhook from tilting/sliding roof frame through slot in slide rail (8) using screwdriver. If the clips (7) cannot be unhooked:↓ Remove slide rail (8)
16	Unhook rail (10) on tilting/sliding roof frame towards front	Electric tilting/sliding roof (Code 414a)
17	Remove headliner through right front door
18	Install in the reverse order	Attach bracket (11)