Milling switch opening - AR68.20-P-2030-01A

COMMERCIALLY AVAILABLE TOOLS

Number	Designation
WH58.30-Z-1011-20A	Universal profile milling machine with surface milling cutter (3 single lip miller Ø 5 x 60mm, 2 single lip miller Ø 5 x 90mm, templates, fixing supports for model 129, 170, 202, 208, 210, 463), Firma Fetzer GmbH 75446 Wiernsheim-Pinache

Position manual router (2) on mounting and clamping device and carefully press down on handles (6, 13) against surface of clamped cover. Tighten handle (6).
Do not switch on manual router.

Fig 1: Pressing Down On Handles Against Surface Of Clamped Cover
Set depth limitation pin (8), with black stop screw (19) to cutting depth of 1.6 mm using feeler gauge (18).
Arrest depth limitation pin (8) with arresting screw (9). Loosen handle (6).

Fig 2: Identifying Depth Limitation Pin, Stop Screw, Feeler Gauge, Arresting Screw & Handle
Switch on manual router, grip both handles (6, 13) and press down against stop. Tighten handle (6).

Fig 3: Pressing Down On Handles Against Stop
Smoothly guide manual router (2) in clockwise direction (direction of arrow) along duplicating template on surface of mounting and clamping device (1). Loosen handle (6).
Switch off manual router (2).

Fig 4: Guiding Manual Router In Clockwise Direction