Pressing off, pressing in radial seal at side of rear axle housing - AR35.31-P-0540-05C

	Universal hypoid-gear lubricants	As of 01.04.98	BB00.40-P-0235-07A
	Radial seal on side of rear axle housing and connecting flange modified	Only model 202.085 with transmission 722 and rear axle center assembly diameter 185, 202.134/194 except CODE (450) taxi version, 210.007 with rear axle center assembly diameter 185	BT35.31-P-0013-01A

Fig 1: Identifying Drift (140 589 10 15 00)

Pressing off 

Rear axle center assembly without side bearing cover.

1. Press radial seal (32a) out of housing using a suitable screwdriver.

   198 mm dia. rear axle center assembly in assembly stand shown 

   Fig 2: Identifying Radial Seal Out Of Housing

   

Pressing in 

2. 2 Coat the lip of the new radial sealing ring (32a) with universal hypoid gear oil.
3. Push in radial seal ring (32a) using drift (032c).

   Shows rear axle center assembly 198 mm ø 

   Fig 3: Pushing Radial Seal Ring