Removing and installing rear rubber mounts of rear axle center assembly suspension - AR35.10-P-0050-02D

Fig 1: Identifying Removal And Installation Tool (210 589 02 43 00)

Removing rubber mounts 

1. Using the removal and installation tool 210 589 02 43 00 with parts 15 and 16, pull both rubber mounts (62) forwards out of the rear axle carrier (015, 016).
   Fig 2: Identifying Rear Rubber Mounts And Rear Axle Center Assembly

   

   Removing rubber mounts 

   Insert rubber mounts from the front in the cross member so that the designation " top  " points upwards vertically (arrow).

   Fig 3: Locating Top Points For Installing Rubber Mount

   
2. Using the removal and installation tool 210 589 02 43 00 parts 07 and 15, pull forward both rubber mounts (62) into the rear axle carrier until the installation washer (07) abuts the rear axle carrier (07, 015).
   Fig 4: Identifying Rubber Mounts, Washer And Rear Axle Carrier