LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 1998 >> SL600 >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Rear Axle -- 129 Chassis >> Testing & Repair >> Pressing out and drawing in rear axle shaft at rear axle shaft flange - AR35.30-P-0115 >> Pressing out and drawing in rear axle shaft at rear axle shaft flange - AR35.30-P-0115-03A

Pressing out and drawing in rear axle shaft at rear axle shaft flange - AR35.30-P-0115-03A

Fig 1: Identifying Extraction And Installation Tool (210 589 03 43 00)
G04636287

    Removal: 

  1. Cut the thread M8 (models 129, 140, 202 as of 08/93, 210 with core hole bore).
    Fig 2: Cutting Thread
    G04636288
  2. Use removal and insertion tool SPECIAL TOOL to press firmly attached rear axle shaft out of the rear axle shaft flange.

    Installation 

    IMPORTANT On rear axle shafts which are glued in before installation clean the splined shaft profile and rear axle shaft flange mechanically.

  3. Pull in rear axle shaft using the extraction and insertion tool SPECIAL TOOL .
    Fig 3: Pulling In Rear Axle Shaft
    G04636289
scientia non olet · About LEMON Manuals