Removing and installing radiator - AR20.20-P-3865HW

ENGINE 601 in MODEL 124, 201 

ENGINE 602 in MODEL 124, 201 

ENGINE 603 in MODEL 124, 126, 140 

Fig 1: Identifying Radiator Removal/Install Components - 601, 602, 603

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Removing, installing
1	Remove bottom engine compartment panel
2	Drain coolant		ra20006010010x
3.1	Unbolt oil lines at radiator, pinch off	only models with automatic transmission	Fig 2
4	Unclip holder (15) for vent hose
5	Pull out flat spring (1)
6	Take off fan shroud (11) and place over the fan
7	Detach coolant hoses (10, 14)		*WH58.30-Z-1001-06A
			*WH58.30-Z-1002-06A
8	Take out expanding rivets (5)
9	Remove radiator panel (6, 7)
10	Pull off retaining clip (4)
11.1	Unbolt front end crossmember	Model 140 and 201.128
12	Detach hood cable
13.1	Take off front bumper	Model 201.128 with AC
14	Unbolt condenser from radiator
15	Pull out flat spring (2)
16	Lift out radiator (9)	Installation model 140:  With new radiator ↓
		Align radiator to front end crossmember	AR20.20-P-3865-02A
17	Install in the reverse order
18	Inspect cooling system for leaks		AR20.00-P-1010HA

Fig 2: Identifying Clamp (000 589 40 37 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.