Removal and installation of the lamp failure monitoring unit - ra54001406075x(6075)
Model 140
Operation no. of operation texts and work units or standard texts and flat rates
| Ground cable at battery | disconnect, connect. |
| Fuse box cover (1) | take off, fit on. |
| Wiper system relay (K26) | take out of holder, insert. |
| Wiper system relay holder (2) | take off, fit on. |
| Screws (3) | unscrew, screw in. |
| Relay box cover (4) | take off, fit on. |
|
NOTE:
As of 09/95 it is first necessary to remove the combination relay (N10/2).
|
|
| Lamp failure monitoring unit (N7) | remove, insert; insert the retaining lug (arrow) first. |
|
NOTE:
As of approx. 2/94 the lamp failure monitoring unit (N7) is held in place with an additional bracket.
|