LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 1998 >> S600 >> Repair and Diagnosis >> Accessories & Equipment >> Wiring System (Data Link Connectors, Pwr Dist., Grnd Dist.) >> Electrical System, Equipment & Instructions - 140 Chassis >> Repair & Adjustments >> Disconnection/connection notes for electrical connectors - ra54001400010x(0010)

Disconnection/connection notes for electrical connectors - ra54001400010x(0010)

Model 140 

Connectors of electronic accelerator pedal or Tempomat cruise control M16/1x1, M16/2x1, M16/3x1 at right front wheelhouse and M16/4x1 at left front wheelhouse. 

Unplugging 

  1. Press back detent hook with screwdriver; when doing this, hold cover of connector tight and turn to the left.
    NOTE: Turning the cover is assisted by the integral spring.
    Fig 1: Pressing Back Detent Hook
    G05439017Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
  2. Take off connector.

Plugging together 

  1. Fit on connector and turn cover to the right against the spring force until the detent hook engages.

Engine separation point X26/2 at right front wheelhouse. 

Unplugging 

  1. Turn over locking bar in direction of arrow as far as the stop.
  2. Take off connector.

Plugging together 

  1. Fit on connector.
  2. Turn over locking bar in direction of arrow as far as stop (b).
Fig 2: Turning Over Locking Bar
G05439018Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Connector, starter harness X27 

Unplugging 

  1. Pull off rubber grommet (arrow) below the vehicle on the right of the firewall.
  2. Unscrew union nut and unplug connector.
    Fig 3: Locating Rubber Grommet
    G05439019Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
  3. Unclip connector (arrow) in right front footwell.

Plugging together 

  1. Clip in connector (arrow) in right front footwell.
  2. Plug in connector on underside of vehicle and screw on union nut.
  1. Fit on rubber grommet (arrow) below the vehicle on the right of the firewall.
Fig 4: Locating Connector Clip And Rubber Grommet
G05439020Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Connector, emergency tensioning retractor/airbag X11/7, X11/13 in front right footwell Unplugging 

  1. Push locking bar in direction of arrow as far as the stop (a).
  2. Take off connector.
Fig 5: Pushing Locking Bar
G05439021Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Plugging together 

  1. Fit on connector so that the markings A and B on the locking bar and on the connector housing are lined up. P54-5141-13
  2. Push locking bar in direction of arrow as far as the stop (b).

Connector, door separation point X35/1, X35/2 at A pillar 

Unplugging 

  1. Use screwdriver to press out locking bar for the respective row of connectors or couplings approx. 5 mm in direction of arrow.
  2. Pull out connector or connector.

Plugging together 

  1. Plug in coupling or connector.
  2. Press in locking bar.
Fig 6: Pulling Out Connector
G05439022Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Connector, door separation point X35/3, X35/4 at B pillar 

Unplugging 

  1. Take off cover.
  2. Turn connector 180° to the left with special tool 140 589 00 09 00.
  3. Take off connector.
Fig 7: Turning Connector
G05439023Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Plugging together 

  1. Fit on connector and turn 180° to the right with special tool 140 589 00 09 00.
  2. Fit on cover.
Fig 8: Identifying Connector
G05439024Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Special tool 

Fig 9: Identifying Special Tool (140 589 00 09 00)
G05439025Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
scientia non olet · About LEMON Manuals