LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 1998 >> S500 >> Repair and Diagnosis >> Steering >> Power Steering >> Steering - 140 Chassis >> Testing & Repair >> Remove/install drag link - AR46.40-P-0100B

Remove/install drag link - AR46.40-P-0100B

MODEL 140 

Fig 1: Identifying Drag Link Components - Model 140 (1 Of 2)
G04713905Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Fig 2: Identifying Drag Link Components - Model 140 (2 Of 2)
G04713906Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
MODIFICATION NOTES

10.9.03 Reference to adjusting toe on front axle replaced by reference to chassis alignment Step 8  
REMOVINGINSTALLING Remove/install     
DANGER Risk of death  caused by vehicle slipping or toppling off of the lifting platform. Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer. AS00.00-Z-0010-01A
NOTES Notes on self-locking nuts and bolts   AH00.00-N-0001-01A
1.1 Remove engine compartment paneling Vehicles with gasoline engines  
1.2 Remove bottom section of soundproofing Vehicles with diesel engines ra94001405305x
2 Detach steering damper (46) from drag link TORQUE SPECIFICATION *BA46.40-P-1001-03A 
3 Unscrew nuts on drag link (11) IMPORTANT Counter the ball pin using an Allen wrench if necessary.  
    TORQUE SPECIFICATION *BA46.40-P-1001-04A 
4 Install thrust piece (051) SPECIAL TOOL Fig 3
5 Press drag link (11) off steering gear pitman arm and steering idler arm using puller (050) IMPORTANTInstallation:  Clean grease off tapers and press the ball joints of the drag link securely into the steering arms.  
    SPECIAL TOOL Fig 4
6 Check joints of drag link (11) for play and damaged rubber boots Replace drag link (11) if necessary.  
    IMPORTANT The left drag link joint is a pivot joint with a swivel range of max. 2°. This prevents pivot movements of the drag link.  
7 Install in the reverse order    
8 Check front wheel toe and adjust if necessary See: ↓  
    Perform a wheel alignment check AR40.20-P-0200A
TORQUE SPECIFICATION STEERING DAMPER

Number Designation Model 140
BA46.40-P-1001-03A Steering damper to drag link Nm 40
TORQUE SPECIFICATION DRAG LINK

Number Designation Model 140
BA46.40-P-1001-04A Self-locking nuts of drag link Stage 1 Nm 50
Stage 2 ∠ ° -
Fig 3: Identifying Thrust Piece (140 589 00 63 00)
G04713907Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Fig 4: Identifying Puller (140 589 00 33 00)
G04713908Courtesy of MERCEDES-BENZ OF NORTH AMERICA.