Removing and installing driver's seat cushion - AR91.10-P-1070K

MODEL 208 

Fig 1: Identifying Driver Seat Cushion Remove/Install Components (1 Of 2)

Fig 2: Identifying Driver Seat Cushion Remove/Install Components (2 Of 2)

	Removal, installation
1	Front seat removed		AR91.10-P-1000K
2	Pull off hand wheel (2) and handle (3)
3	Unscrew screw (4), unhook cover (5) on seat adjuster (11) and remove
4	Unscrew screw (6), unhook cover (7) on seat adjuster (11) and remove
5	Unhook springs (8)
6	Unscrew screws (9)		*BA91.10-P-1002-01A
		Use 4mm Allen wrench socket
7	Unscrew screws (10) on left and right of seat cushion frame	Use T30 inner Torx socket
8	Remove driver's seat cushion (1) from seat adjuster (11) toward front while pulling pivot spring (12) out at rear of seat cushion frame (arrows)	When installing insert pivot spring (12) into seat cushion frame
9	Put down driver's seat cushion (1)
10	Reinstall in opposite order

FRONT SEATS

Number	Designation		Model 208
BA91.10-P-1002-01A	Screw on bearing plate for inclination adjustment shaft	Nm	10