  |
Remove/install |
|
|
 |
Risk of injury.
Injuries may result when performing testing or repair work on airbag or emergency tensioning retractor units. |
Store airbag unit with expulsion area on top, do not subject to temperatures above 100°C. When working on these units, disconnect the power supply. |
AS91.00-Z-0001-01A |
|
Risk of injury.
Injury may result when the tension in the spring in the automatic belt retractor is released. |
Never disassemble automatic belt retractors. |
AS91.00-Z-0002-01A |
 |
Instructions for performing repair, body work and welding on vehicles with airbags and ETR units |
Models 129 as of 1.7.93, 163, 168, 170, 202 as of 1.7.93, 208, 210, 463, 638, 901, 902, 903, 904 |
AH91.00-P-0002-01B |
|
Evaluation of airbags and emergency tensioning retractors on accident vehicles |
Models 129 as of 1.7.93, 163, 168, 170, 202 as of 1.7.93, 208, 210, 463, 638, 901, 902, 903, 904 |
AH91.00-P-0006-01B |
 |
Legal regulations on handling and storing airbags and emergency tensioning retractors |
Model 124, 129, 140, 163, 168, 170, 202, 208, 210,314, 316, 318, 463, 638, 901, 902, 903, 904, 950, 952, 953, 954, 970, 972, 974, 975, 976 |
AH91.00-P-0004-01A |
| 1 |
Remove rear side paneling (1) |
|
AR68.30-P-4780KA |
| 2 |
Unscrew screw (2) from front upper belt guide fitting |
Screw on front seat belt guide bracket |
*BA91.40-P-1002-01A |
| 3 |
Unscrew screw (3) from front automatic belt reel |
Screw on front automatic belt retractor |
*BA91.40-P-1004-01A |
| |
|
Bolt on belt end fitting |
*BA91.40-P-1001-01A |
| 4 |
Disconnect connector from tensioning retractor (5) |
|
|
| 5 |
Remove seat belt (4) |
|
|
| 6 |
Install in the reverse order |
|
|